Drolet UL 1482 Manuel d'utilisateur

READ AND KEEP THIS MANUAL FOR REFERENCE 45280 OWNER’S MANUAL EASTWOOD 1500/1800 EPA WOOD STOVES US ENVIRONMENTAL PROTECTION AGENCY PHASE

91.3.1 Reduced clearances using shielding You may decrease the minimum clearances to combustible materials by installing heat radiation shields bet

10 1.4 FLOOR PROTECTOR If the stove is to be installed on top of a combustible floor, it must be guarded by a non-combustible material extending at

11 SECTION 2.0 CHIMNEY (FLUE SYSTEM) 2.1 DEFINITIONS For clarity, the following definitions should be used with respect to these instructions: •

12 If you are using a masonry chimney, it is important that it be built in compliance with the specifications of the Building Code. It must be lined

13 FIGURE 2.2 Minimum Height of the Chimney 2.2.1 Step by step installation of your factory-built chimney The way to install your chimney may va

14 FIGURE 2.2.1 (A) Typical installation through the wall 1- Start by positioning your stove where you would like it to go, taking into account

15 2- Once the opening completed, you need to frame in the area to allow for the installation of a wall thimble. A wall thimble is not required for

16 5- You can now install the wall support. Simply slide the wall support up to the tee, ensuring that the adapter on the support engages with the

17 8- Finally, twist on your rain cap and you can head back inside. 9- You are now ready to connect your chimney to your stove. Simply install

18Typical installation through the ceiling FIGURE 2.2.1 (B) Typical Installation Through the Ceiling 1- Place your stove where you would like

1INTRODUCTION Stove Builder International, one of the most important wood stove and fireplace manufacturers in North America, congratulates you on y

19 2- Before you install the ceiling support, you need to frame the area. 3- To install the ceiling support, just slide the assembly into the

206- Now, you can add additional chimney sections. Continue adding chimney lengths until a height of about 2 feet below the next ceiling level. An a

219- You are now ready to connect your chimney to your stove. Simply install the inter-connecting stove pipe between the stove pipe adapter and the

22 FIGURE 2.2.2 (B) Factory Built Thimble

23 FIGURE 2.2.2 (C) Brick Thimble

24 2.3 CHIMNEY CONNECTOR Your chimney connector (commonly called stove pipe) and chimney must have the same diameter as the stove’s exhaust outlet.

25 FIGURE 2.3 (B) Minimum Slope 2.4 DRAFT Your Eastwood EPA stove’s performance will be optimised if it is installed with a chimney (flue) sys

26combustion present. • Opening a window slightly on a calm (windless) day alleviates any of the above symptoms. • The house is equipped with a w

27SECTION 3.0 OPERATION Keep these instructions for future reference. WARNING: • ANY MODIFICATION OF THE APPLIANCE THAT HAS NOT BEEN APPROVED I

28 • Even though your Drolet has been specifically designed and tested to prevent smoke spillage, always open the door slowly as this will minimise

2 TABLE OF CONTENTS REGISTER YOU WARRANTY ONLINE...1 TEC

29Your Drolet stove is designed to burn WOOD ONLY. Do not burn coal, charcoal, or trash in the unit. Highly flammable items such as trash may igni

30stove and void the warranty. Logs containing chemical additives burn a lot hotter and were designed for decorative fireplaces. Decorative firepla

31established. Once the firebox is hot, the air control can be partially closed. After 30 minutes to one hour, you can close the air control comple

32 SECTION 4.0 MAINTENANCE 4.1 CLEANING AND PAINTING YOUR STOVE Clean the stove frequently so that soot, ash, and creosote do not accumulate. Do

33 4.4 ASH REMOVAL USING THE ASH DRAWER CAUTION: ASHES CAN START FIRES, EVEN AFTER SEVERAL DAYS OF INACTIVITY. NEVER DISPOSE OF ASHES IN A COMBUS

344.5 CHIMNEY (FLUE) CLEANING Regular chimney (flue) maintenance, as well as good burning practices, are required to prevent chimney fires. When wo

35 DROLET LIMITED LIFETIME WARRANTY The warranty of the manufacturer extends only to the original consumer purchaser and is not transferable. This

34.5 CHIMNEY (FLUE) CLEANING ...34 DROLET LIMITED LIFETI

4TECHNICAL SPECIFICATIONS EASTWOOD 1500 Recommended Surface: 500 to 1500 sq. ft. Maximum heat output (seasoned cordwood): 45,000 BTU Maximum e

5EASTWOOD 1800 Recommended Surface: 850 to 1800 sq. ft. Maximum heat output (seasoned cordwood): 60,000 BTU Maximum efficiency (default EPA eff

6TIPS ON WOOD HEATING Wood is a renewable energy. It is also a very clean heat source when used with appliances that are certified by the U.S. Envir

7SECTION 1.0 INSTALLATION When installed and operated as described in these instructions, the Eastwood EPA wood stove is suitable for use as a fre

81.2 POSITIONING THE STOVE It is very important to position the wood stove in an area that will favour the most efficient heat distribution throug